The ML 400		 Temp:
     Press the "Temp" button once to display the "set" temperature.  To change the set temperature, press the pad a second time before the LCD stops flashing.  Each press of the "Temp" button will continue to either raise or lower the set temperature.
     If the opposite direction is desired, release the pad and let the display revert to the current water temperature.  Press the pad to display the set temperature and again to make the temperature change in the desired direction.
     After Three seconds, the LCD will automatically display the last measured spa temperature.

Jets:
     Press the "Jets" button once to turn the pump one or off, and to shift between low and high speeds if equipped.  If left running, the pump will turn off after a time-out period. The pump time on some systems may be as long as 4 hours.
     On spas with out circulation pumps (Z-60 and Leisure Max)  the low speed of the pump runs when the blower is on.  It may also activate for at least one minute every 30 minutes to detect the spa temperature and then to heat to the set temperature (if needed), depending upon the mode.  When the low speed turns on automatically (for filtration or temperature), it can not be turned off from the panel; the high speed may be started.


 Continued . . .    

The ML 400 Quick Reference Guide;

Overview:

The ML400 Controls have been installed on all models which use one main pump (which can include a circulation pump and a blower).  The upgrade also includes the new GL series control Paks.  This upgrade paves the way for our PC computer driven diagnostic system.  It also will conform to standards for non-metal casings for electrical equipment.  Together with our new line of Italian pumps built on a 50 cycle platform, our spas will easy surpass CE standards for 2007.

Hydro-Spa Models:

To be used on all single pump models using the Balboa GL series pack.  The Lexxus (LX 74), The Tiara (2004).

Initial Start-Up:

When your spa is first started, it will go into priming mode (after displaying some configuration information). 

The priming mode will last up to 4 minutes and then the spa will begin to heat and maintain the water temperature in the Standard Mode.  You can exit Priming Mode early by pressing "Temp". .

ML700

HydroSpa Europe  830 East Morningside Drive Atlanta GA 30324 (01) 404 870 2109

 Home   |  Models  |  Ex-Im Financing  |  Dealer Sign-Up  |  e-mail us  |  Dealers  |   Contact Us